Upgrading Your Original Knew Concepts Saw

Andrew was lucky to trial the original Knew Concept…..
Read More


No Entry


Andrew was lucky to trial the original Knew Concept saw before they were commercially available and over the 3 years since they first appeared on the market there have been several alterations. The most recent models have a lever tensioning system to enable you to quickly and accurately replace and tension the saw blade.

There is an upgrade kit available that is designed to update early model Knew Concepts saws to add lever tensioning as well as the larger blade sizes and easy-thread countersunk throats added to later saws.

In this film Andrew shows you the fitting of the upgrade kit and the slight modification of the saw frame.

This kit will only fit early model saws (pre 2010) that have a spring pressing against the upper clamp.

Kit Contents:
1 each: new upper and lower blade clamps. Revised with larger blade holes, and countersunk throats.
1: 5/64″ hex wrench
1:“H” frame upgrade bridge
1: Tension lever with pre-installed axle
1: brass tension knob
This kit will only fit early model saws (pre 2010) that have a spring pressing against the upper clamp.

The upgrade kit is only available from the manufacturers. Click Here to Order

Click here to download written instructions.