Back to Gallery

KoreanClawRing by Thomas965

Split shank ring made for a very dear colleague and friend. It will be worn on the right index finger. I used heirloom sterling silver from our family for this special project. The 3 mm shank was home-drawn and hammered before bending into shape. The claw-like ornament was casted in delf clay using a prototype I made from 3mm copper sheet. The ring represents her perseverance needed as a successful woman in science.

4 thoughts on “KoreanClawRing”

  1. Beautiful work Thomas. The special meaning and care put into it is obvious. How did you secure the ring to get the different flush set angles?

  2. Hi Teresa, Thanks! During the flush setting I put it the ring relatively ‘high’ in a ring clamp and adjusted the angle of the claw for each individual stone such that the flush setting could be done at 90 degree (i.e. burnisher is straight down). The same procedure was done for the stone in the front. This is a bit of an eyeballing and checking back-and-forward thingy. Takes a bit of time, but works well. Somehow this free-style type setting with a ring clamp in one hand and a very pointy burnisher in the other works best for me. Both hands are connected together very vigorous and it looks as if you are writing with the burnisher around the stone. Hope this description makes sense to you.

Leave a comment

Your email address will not be published. Required fields are marked *