Home » All Films » Techniques » Soldering » Soldering On A Dome – Part 3
Soldering On A Dome – Part 3
Soldering on balls or embellishments onto you jewellery is a good way to create an extra dimension and detail to what might be a plain surface. Soldering the embellishments onto a flat surface is fairly easy but what happens should your design be a little more 3 dimensional and you have a small curved surface to solder the embellishments onto?
This is where you will run into problems. Solder the ball onto one side and then you go and solder some other balls onto the other side only to find out that your previously soldered balls fall off due to the solder melting. So how do we stop this happening? One way is to use different melting point solder. But this is not always possible due to the construction of the item, we may have used a couple of melting point solders already. So how can we do it? Andrew shows you how in these few films.



