Home » All Films » Techniques » Techniques – Flush setting with Thin Metal Part Four
Techniques – Flush setting with Thin Metal Part Four
This film was inspired by a ring that was brought in for Andrew to remodel. It is often the case that stones need to be set within metal that is too thin to make a satisfactory job. In the case of a platinum wedding band that was set with diamonds that were too deep for the ring, the previous 'craftsman' soldered on jump rings beneath where the bottoms of the diamonds protruded out of the ring and into the finger. From the outside of the ring, the rings looks fine, but when the ring is examined the ring looks awful.
So what do we do if the metal we want to set stones into is too thin and the stones are likely to protrude out the back of the metal? Andrew creates a bi metal ring using silver and gold and a disc cutter to stamp out the gold discs to give the diamonds some support.


