Introduction To Stone Setting

Learning how to set stones in jewellery is such an amazing and rewarding technique and is such a fantastic step up if you are looking to expand your repertoire. In this section we briefly cover the basics to get you started.

There are plenty of ways to incorporate gemstones into your jewellery. From the most basic bezel setting right up to the micro pave work. And again like all techniques you have learnt and mastered so far, you need to start off with the basics and work up. Gemstones come in all shape and sizes so you need to have basic gemstone knowledge too to understand what gemstones can be set in certain ways.

By now, if you have been making jewellery for a while, you will have most of the tools needed. A lot can be made or adapted so there is no need to buy the most expensive setting equipment because after all it is your skill that needs to be improved and expensive equipment is no substitute for experience.

  • Bezel Rocker
  • Pusher
  • Burnisher
  • Ring Clamp
  • Thermo Loc
  • Needle Files
  • Pendant Drill or Dremel

We will start off with the understanding of bezel setting and getting the bezel the right height for the stone. Claw setting is a bit more advanced, you can make or buy the setting you need for this style of setting. Next we will look at flush setting, this is where the stone looks like it has just been pushed into the metal. this takes a lot of skill and accuracy. Then finally we will take a look at Pave work. This takes a lot of skill and patience and a few more tools to complete this type of setting.

Stone Setting

There are plenty of ways to incorporate gemstones into your jewellery. From the most basic bezel setting right up to the micro pave work. The following films take you through a few of the amazing setting films we have here on At The Bench. We start of with the basic bezel setting. It may be basic but there is so much to learn from this one simple setting technique.

Bezel Setting

By starting off with a round cabochon stone and using bearer wire, making a bezel is straight forward. Andrew Berry takes you through, step by step, showing you exactly how to make the bezel fit the stone perfectly. If you get the bezel to fit the stone exactly at this stage it will make the setting of the stone so much easier.

Watch Now

Claw Setting

We look at how to set a gemstone into a prefabricated setting. Using a burr to help cut the seat for the stone to sit on takes patience and good eyesight or as Andrew uses, an optivisor.

Watch Now

Flush Setting

Accuracy is they key to flush setting. When setting stones in this way there is not a lot of metal to ease over the stone, perhaps 1/5 mm? So it pays to work ‘little and often’, trying to see if the stone will fit after each stage. You do not want to make the hole too wide of the stones will inevitably fall out.

Watch Now

Pave Work

Good pave work is usually carried out under a microscope but the cost of a microscope is pretty high so we usually make do, and perfectly adequate, with an Optivisor to give us that close up magnification. Attention to detail is paramount and having perfectly proportioned stones really help too.

Watch Now

Learning Path

Privacy Overview

This website uses cookies so that we can provide you with the best user experience possible. Cookie information is stored in your browser and performs functions such as recognising you when you return to our website and helping our team to understand which sections of the website you find most interesting and useful.